Internal brake cable routing Posts

Internal Top Tube Cable Routing

Internal Top Tube Cable Routing

I have done this procedure several times on completed frames, but it is sensible to do it before the tube is brazed. Partly because it reduces the chances of frame distortion when you are brazing into tubes after assembly and partly because if it goes wrong it will be easy to re-do! I have only used brass tubes for this procedure, though it would be possible to use stainless tubes if you can obtain malleable enough ones of the correct diameter. Ceeway and various model making suppliers supply 7mm diameter brass tube with approximately 0.4mm walls. You need 500mm lengths to do the job. A 7mm tube will take a complete brake cable, holding it tightly. It would be possible to forgo the internal tube and simply run the cable in and out of the top tube but I suspect this may cause unacceptable noise from the cable being free inside the top tube, and allow water ingress.